There are three ways to repair a hole in drywall. You can patch it yourself, you can hire a handyman or you can hire a professional to do it for you. The cost of repairing a hole in drywall will depend on the size of the hole. Small holes and indentations will usually require a simple fix. Larger holes will need more time and work. A handyman company in St. Petersburg will charge between $70 and $130 an hour for a repair.

To fix a hole in drywall, start by cutting out the area. You will need lumber and plywood for this step. If you have access to a stud finder, you can use it to locate the studs on either side of the hole. Also, a carpenter’s square can be used to make a line at least a couple inches below the hole.

Once the hole is cut, apply a small amount of joint compound. This compound should be at least 1/8 inch thick. Ideally, the patch should be the same thickness as the wall where the hole is. Apply the compound on both sides of the patch and spread it out evenly. Allow the compound to dry for at least 24 hours before applying a second coat. When the first coat is dry, sand the area with sandpaper to smooth out any imperfections.

Afterwards, remove any sanded dust from the wall. A drop cloth and vacuum should be used to collect any excess dust. After the drywall is completely dry, you can paint the repaired area. However, you should wait at least 24 hours between coats to prevent the compound from crumbling.

Next, you need to determine the studs in your walls. The studs are the wood pieces behind the wall anchors. These can be found by using a stud finder or by tracing a straight edge along the nail pop.

For a larger hole, you might want to try mesh drywall tape. These types of patches can cover large holes, but are not as seamless as traditional drywall. Mesh tape can be purchased at home improvement stores for about $15. It comes in a 250-foot roll.

Drywall spackling compound is also an option for repairing dents. You can use a putty knife to apply the filler. Lightly sand the spackling after it is dry. Do not overfill the spackling; it is best to apply it on top of a piece of paper tape.

In addition, you should also sand any rough spots. Depending on the size of the hole, you may need to use a claw hammer or metal snips to help you.

Lastly, you should apply a coat of primer and paint. This will ensure that the patch is even, and that the patch will stay put. Wait at least 24 hours between coats to allow the primer to dry.

Repairing a hole in drywall is easy and inexpensive. Usually, the process takes only a few hours. However, it can take longer if you need to cut out a section of the drywall.